Aluminium glazing spraying · Bath

Aluminium glazing spraying in Bath.

Curtain walls, window frames and entrance door systems spray-refinished on site. Matched RAL or BS finish. No reglazing, no disruption to building occupants. Delivered across Bath and Somerset. Facade cleaning, frame restoration and commercial decorating across Bath. A World Heritage city of Bath stone and listed Georgian frontages means heritage-safe methods come first. DOFF steam cleaning over pressure, sympathetic finishes, and restoration before replacement on period metalwork and shopfronts.

Bath programme

How we run aluminium glazing spraying schemes locally.

1. 01 · Survey

   Confirm glazing system type, substrate condition, RAL reference (gloss-meter read on a clean reference panel), adhesion test on existing finish, and access method. Restoration only goes ahead if the substrate holds.

2. 02 · Specification

   Two-pack tie-coat over light mechanical abrasion, matched RAL topcoat at 60-80 µm. System selected for UV stability and matching sheen to adjacent panels. Service-life expectation written into the spec.

3. 03 · RAMS

   Project-specific RAMS including glazing-protection masking method, spray-containment plan for public routes, COSHH for tie-coat solvents, and access schedule.

4. 04 · Delivery

   Mask all glazing, gaskets and ironmongery. Prepare, prime and apply within the same shift where access permits. Demask at end of each phase. Glass checked before reopening.

5. 05 · Handover

   Before/after photo record, gloss reading on completed panels, written service-life note per scheme.

Frequently asked · Bath

What clients in Bath usually ask first.

Is your cleaning safe for Bath stone and listed facades?

Yes. DOFF superheated steam at low pressure lifts soiling without abrading the stone. We sample-clean a test area and agree the method before touching the elevation.

Do you work in the conservation area and on listed buildings?

Regularly. We work to the substrate and the consent conditions, and flag anything that needs listed-building or planning sign-off before we start.

Can you match heritage colours on shopfronts?

Yes. We identify the existing colour and apply a matched RAL or BS finish, restoring period metalwork rather than replacing it where the substrate is sound.

Is the glass protected throughout?

Glazing, gaskets, ironmongery and sealants are masked before primer goes on. Glass is inspected at demask before any floor or wing reopens.

Will it last as long as factory powder coat?

Not quite, but a properly specified, well-prepared two-pack system gives a credible service life. We confirm the expectation in writing per scheme.

Can it be done while the building is occupied?

Yes. Most schemes are delivered phased, floor by floor or elevation by elevation, with each section reopened as we demask.

Can you match a faded or inconsistent RAL?

Yes. We sample on site and match to the current colour, not factory-fresh. Where estate consistency is the goal, a single reference colour is agreed and applied across the whole scheme.

How long until staff can open the windows?

Touch-dry within an hour; full cure varies by system. We agree the no-touch window at survey and leave it on the handover sheet.

Recent work

Recent work across Somerset.

• Tesco · TauntonView case study →