Aluminium glazing spraying · Swindon

Aluminium glazing spraying in Swindon.

Curtain walls, window frames and entrance door systems spray-refinished on site. Matched RAL or BS finish. No reglazing, no disruption to building occupants. Delivered across Swindon and Wiltshire. Warehouse coatings, resin floors and industrial decorating across Swindon. The town's distribution and logistics estates along the M4, and the manufacturing units that came with them, are the core of the programme. Live-site wall and steel coatings, epoxy floors specified to forklift traffic, all delivered zone by zone.

Swindon programme

How we run aluminium glazing spraying schemes locally.

1. 01 · Survey

   Confirm glazing system type, substrate condition, RAL reference (gloss-meter read on a clean reference panel), adhesion test on existing finish, and access method. Restoration only goes ahead if the substrate holds.

2. 02 · Specification

   Two-pack tie-coat over light mechanical abrasion, matched RAL topcoat at 60-80 µm. System selected for UV stability and matching sheen to adjacent panels. Service-life expectation written into the spec.

3. 03 · RAMS

   Project-specific RAMS including glazing-protection masking method, spray-containment plan for public routes, COSHH for tie-coat solvents, and access schedule.

4. 04 · Delivery

   Mask all glazing, gaskets and ironmongery. Prepare, prime and apply within the same shift where access permits. Demask at end of each phase. Glass checked before reopening.

5. 05 · Handover

   Before/after photo record, gloss reading on completed panels, written service-life note per scheme.

Frequently asked · Swindon

What clients in Swindon usually ask first.

Can you coat a working distribution centre?

Yes. We phase by zone so picking and dispatch carry on around us, reopening each area before moving to the next.

Do you do warehouse floor coatings?

Yes. Epoxy and polyurethane systems specified to the slab and the traffic load, with the downtime agreed up front, not assumed.

What about access in high-bay units?

MEWPs, scaffold and mast climbers as the building needs; agreed at survey alongside the traffic-management plan.

Is the glass protected throughout?

Glazing, gaskets, ironmongery and sealants are masked before primer goes on. Glass is inspected at demask before any floor or wing reopens.

Will it last as long as factory powder coat?

Not quite, but a properly specified, well-prepared two-pack system gives a credible service life. We confirm the expectation in writing per scheme.

Can it be done while the building is occupied?

Yes. Most schemes are delivered phased, floor by floor or elevation by elevation, with each section reopened as we demask.

Can you match a faded or inconsistent RAL?

Yes. We sample on site and match to the current colour, not factory-fresh. Where estate consistency is the goal, a single reference colour is agreed and applied across the whole scheme.

How long until staff can open the windows?

Touch-dry within an hour; full cure varies by system. We agree the no-touch window at survey and leave it on the handover sheet.